Hard Carrying Case for UHS2
A carrying case that is compatible with the AC Milligauss Meter.
Hard Carrying Case for USSVM2
A hard carrying case that is compatible with the Ultra Stable Surface DC Volt Meter USSVM2
Rubber Boot for GM1 and UHS2
A detachable rubber boot that is compatible with the following products:
Note: image is of a GM1-ST inside a boot. The meter is not included.
Rubber Boot for GM2 & VGM
A detachable rubber boot that is compatible with the following products:
Note: image is of a GM1-ST inside a boot. The meter is not included.
Rubber Boot for MGM
A detachable rubber boot that is compatible with the DC Milligauss Meter Model MGM.
Note: image is of a GM1-ST inside a boot. The meter is not included.
Rubber Boot for USSVM2
A detachable rubber boot that is compatible with the Ultra Stable Surface DC Volt Meter USSVM2
Note: image is of a GM1-ST inside a boot. The meter is not included.
AC Electric Field Meter Model ACEF
This meter measures AC electric field in the vertical direction (same direction as the long axis of the meter). It has a wide frequency range (40 Hz – 20 KHz) and high accuracy (+/-2% of reading +/- 1 count) with … Read More
DC Magnetometer (Gauss) High Stability
The High-Stability DC Magnetometer measures DC and AC field up to 199.99 gauss with 0.01 gauss resolution The High-Stability DC magnetometer reads both DC and AC magnetic field (1-axis) from .01 to 199.99 gauss. Accuracy is +/- 2% of the reading … Read More
High Resistance / Low Conductance Meter HRLC
There is always a problem with ultra high resistance measurements: only a very small amount of current is flowing through the component that is being tested. Therefore certain precautions must be taken to prevent interference from external sources. A grounded … Read More
High Resistance Meter HR2
The Model HR2 meter measures resistance in nine ranges from 1 ohm to 1.9999 Tera ohms (1.9999×1012ohms), and conductance in a single range of 0.00 to 199.99 pS (pico siemens, or pico mhos), all at low voltage of < 2 volts … Read More
RF Field Strength Meter Model RFM1
Technically a “power density” meter, the RF Field Strength Meter detects the electric field of radio and microwaves (RF) from .5 MHz to 3 GHz, and expresses the field strength as power density (.001 to 2000 microwatts/cm2). This is an … Read More
Voltage Touch Monitor VTM
The AlphaLab Voltage Touch Monitor enables personnel to identify voltage problems that usually remain hidden.